ps:multi-thread®

Home / Novedad


ps:multi-thread®

ps:multi-thread®

Forming threads is a time consuming process!
In the past, of course, it was possible to use thread forming tools on the machines. However, this was only possible by using a single tool in the revolver or as an extern solution by using complete thread units being aware that there are a lot of restrictions towards covering the sheet areas and towards the speed.

The new „ps:multi-thread®“ - developed and produced by PASS Stanztechnik AG - can be used as a 6-Station Multitool which is integrated in a one rotable D-Station of a THICK TURRET punching machine.
Economy effect: only using one tool station versus 5 tool stations in the machine!

The „ps:multi-thread®“ is made with 6 positions. These positions can be equipped with thread form units with measurements from M2,5 (and UNC #2-56) to M10 (and UNC 3/8“-16). The changing of the used thread formers is extremely simple and completes the perfection of the „ps:multi-thread®”.  
Economy effect: Tool changing time!

The changing time of two thread sizes is only 1 second.
The most economy effect can be seen in the time-saving production of threads.  A planetary gear wheel in the tool enables a high turning speed at the thread former and thus enables a productivity up to 30 threads per minute. The transmission ratio is i= 1:5.  
Economy effect: Production time!

The stress for the Index-drive motor can be decreased through the gear transmission ratio.
Economy effect: Wear & Tear!

The „ps:multi-thread®“ can be used for sheet-thicknesses up to 8 mm (depends on thread size). Thread forms will be covered without additional changing efforts. The automatic select-function of the single position in the tool allows the use of the „ps:multi-thread®“ within a fully automatic production process.
Economy effect: Process of changeover!

The automatical lubcrication of all guide elements in the tool and the lubrication of the thread formers during the forming process are additional special characteristics of the „ps:multi-thread®“.



Esta novedad pertenece al expositor: PASS STANZTECHNIK AG


Otras novedades del expositor

ps:speed-grinder

ps:speed-grinder...

As you certainly know from your exper...


ps:wheel

ps:wheel...

Rolling Tools- an always consistent t...



«Volver al expositor